ZEV MAGAZINE RELEASE GEN 4-5
$41.99
In stock
Only %1 left
SKU
zev-magazine-release-gen-4-5
ZEV MAGAZINE RELEASE GEN 4-5
$41.99
In stock
SKU
zev-magazine-release-gen-4-5
Product Details
Icarus Precision sells this product with a spring wire as a complete kit.
Intended for use with our ZEV and RXM Modules.
The Zev Technologies Generation 4 and 5 Magazine release for the Glock® is constructed from Billet 6061 Aluminum and Mil Spec hard anodized Black. It has a Honeycomb non-slip f for a more tactile engagement surf. The contact point on the mag release f is ergonomically angled to the rear to allow ease of manipulation in performing magazine changes. The Mag Release takes minutes to install with the use of needle nose pliers and a long shaft, slim, flat head screwdriver.
NOTE: It is easiest to remove and repl the factory Glock® Mag-release Catch Spring for the magazine release installation. Then installing it back in its pin position after you remove the factory unit and repl it with the ZEV&trade component.
- Honeycomb non-slip f for a more tactile engagement surf
- The contact point on the mag release f is ergonomically angled to the rear to allow ease of manipulation in performing magazine changes
- Note: it is easiest to remove and repl theGLOCK Mag Catch Spring for the magazine release installation
| CA FFL Required | No |
|---|
Write Your Own Review